[Bug 22811] Graphical rendering problem in cad program

[wine-bugs at winehq.org]

http://bugs.winehq.org/show_bug.cgi?id=22811





--- Comment #9 from Sergio Callegari <scallegari at arces.unibo.it>  2010-05-28 03:56:26 ---
Hi,

Roderick, can you please check you attached the right screenshot?
Your http://bugs2.winehq.org/attachment.cgi?id=28326 shows exactly the same
problem as mine.

The "Vss" text should go *below* the blue wire at the bottom of the operational
amplifiers (the triangular shapes in the diagram), not *above*.

In other terms, the Vss text should be rendered *to the left* of the alignment
point (i.e. the bottom extreme point of the blue wire under the triangular
shape), *not to the right* of the alignment point (please, read "to the left"
as "to the bottom" and "to the right" as "to the top" if you prefer, since the
text is vertical).

In your attachment, the problem is only mitigated by the fact that by using a
smaller font the bit of text that gets the wrong alignment does not happen to
overlap with other text, but it is still misplaced taking its reference point
on the wrong side.

Hence, if your attachment is the correct one, please have it interpreted as a
confirmation of the bug.

Otherwise, if by mistake you attached a wrong screeenshot, can you be so kind
to upload the right one and maybe specify your fonts setting, so I can try to
reproduce here?

--------

For what concerns the regression status, I can assure that it is a regression,
since former wine versions were definitely ok (with the exception of a few of
them, since this rendering issues has been several time re-inserted/fixed as
others have confirmed).  If I remember properly 1.41 was OK.
I am sorry that I cannot compile wine on the machine I am on, to fully bisect.
If someone can provide a 1.1.41 or 1.1.42 64bit deb, I would really be glad to
help test.

If fixing this is a relatively easy matter of reverting/fixing some recent
patch, it would really be great if it could be done as long as wine is RC,
rather than putting in 1.2 a bug that was not there until a month ago in the
development version. But of course I cannot judge the difficulty of addressing
the issue, nor the current priority, hence in any case thanks for the great
work. I can always keep a 1.1.38 around.

BTW, is it possible to have 2 wine versions installed at the same time (so I
can keep the one doing CAD rendering right and still test the 1.3.x branch when
it is started?)

-- 
Configure bugmail: http://bugs.winehq.org/userprefs.cgi?tab=email
Do not reply to this email, post in Bugzilla using the
above URL to reply.
------- You are receiving this mail because: -------
You are watching all bug changes.