[Bug 3023] Orcad - "Place Part" never tries to put down a part

[wine-bugs at winehq.org]

http://bugs.winehq.org/show_bug.cgi?id=3023


Padrah Zoltan <zoltan.padrah at gmail.com> changed:

           What    |Removed                     |Added
----------------------------------------------------------------------------
                 CC|                            |zoltan.padrah at gmail.com




--- Comment #10 from Padrah Zoltan <zoltan.padrah at gmail.com>  2008-06-09 14:07:05 ---
(In reply to comment #9)
> it still will not allow the user to simulate a circuit once it is
> built. The pspice simulation configuration menus do not even show up in Orcad
> Capture.  
 That can be fixed with some registry tweaks (that would be another bug: why
the installer doesn't create corresponding resigtry entries for pspice?)

> If there is a version that does work well with WINE
> (will properly simulate circuits built in Capture) do let us know.
 I've tried, but I ran into an unimplemented function, here:
http://source.winehq.org/source/dlls/ole32/compobj.c#L2288  (that should be a
feature request, or some hack is needed). Orcad simply says it cannot
initialize the simulation profile.


-- 
Configure bugmail: http://bugs.winehq.org/userprefs.cgi?tab=email
Do not reply to this email, post in Bugzilla using the
above URL to reply.
------- You are receiving this mail because: -------
You are watching all bug changes.