[Bug 13257] bricscad: separators in vertical toolbar rotated by 90 degrees, causing layout problems

[wine-bugs at winehq.org]

http://bugs.winehq.org/show_bug.cgi?id=13257





--- Comment #13 from Ladislav Láska <ladislav.laska at gmail.com>  2008-05-17 05:57:36 ---
(In reply to comment #12)
> OK, I see it now.  Looks like the whole problem is
> that separators are not rotated when the toolbar is
> rotated, as it were.  It happens with any toolbar
> that you drag onto the left or right edges of the
> drawing area; the separator should notice the toolbar
> is now vertical, and draw itself as a horizontal line.
> 
> I wonder if this problem could be demonstrated using
> the toolbar code at http://www.autohotkey.com/forum/topic27382.html
> using autohotkey.
> 
> (And I reproduced the trouble you had using 'winetricks cc580'.
> Ouch.)
> 
> BTW, is this the worst problem you have with bricscad so far?
> (I also noticed that the tip-of-the-day doesn't display properly,
> that the installer fails to launch help, and that help
> has no way to quit.)
> 

Yes, I've noticed the Tip of the day problem a day ago (I haven't noticed since
I don't usualy read Tip of the day). 

I have no problems with help itself. I've tried browsing some topics and it
seemed ok (a little bit slow, but only the treeview). For the first time. I've
tried now and you're right. Strange

But the program itself seems to be working well except those toolbars. It is
the worst problem since I'm used to use them..


-- 
Configure bugmail: http://bugs.winehq.org/userprefs.cgi?tab=email
Do not reply to this email, post in Bugzilla using the
above URL to reply.
------- You are receiving this mail because: -------
You are watching all bug changes.