[Bug 19613] Installation of Total Annihilation original does not run to completion
wine-bugs at winehq.org
wine-bugs at winehq.org
Fri Aug 7 20:50:24 CDT 2009
http://bugs.winehq.org/show_bug.cgi?id=19613
--- Comment #6 from Hugh Perkins <hughperkins at gmail.com> 2009-08-07 20:50:22 ---
Ok, so I got a different error this time, "Install failed! Unable to find
install\revision.gpf". I've seen that error before; I felt at the time maybe
it was because I was using a path that was too long?
Let's go through my actions in detail:
- I used cdemu to load ta cd1 in a virtual drive (simply because it mounts the
cd as /media/TOTAL ANNIL rather than if I mount it by hand it ends up in /cdom)
- I ran WINEPREFIX=/tmp/junk/ta winecfg , and checked the letter of the cd
drive (D:)
- I tried running WINEPREFIX=/tmp/junk/ta wine D:\SETUP.EXE , but it crashed
with a page fault at address 0x7bc4442e (thread 0009)
- So, in the spirit of making it easy for people to follow instructions I might
write later, I ran the setup from winefile:
- WINEPREFIX=/tmp/junk/ta winefile
- in winefile, changed into D:
- double-clicked on 'SETUP.EXE'
- setup launched just fine
- I clicked on 'regular install'
- the installation ran until the message 'unable to find
install\revision.gpf'
Where is install\revision.gpf? Looking at the contents of the cd, it is at
'D:\Install\revision.gpf', with an upper-case 'I'. Maybe it's looking for
'install' and not finding 'Install'?
By the way I had a look for readme.txt. There is a 'README.txt', with
uppercase README, lowercase txt, at D:\README.txt, ie in the root of the cd.
There is no readme.txt at all, in whatever upper/lower case, in the ta
installation target directory itself.
Maybe it's something to do with upper/lower case?
--
Configure bugmail: http://bugs.winehq.org/userprefs.cgi?tab=email
Do not reply to this email, post in Bugzilla using the
above URL to reply.
------- You are receiving this mail because: -------
You are watching all bug changes.
More information about the wine-bugs
mailing list