[Bug 32224] New: LTspice: selected text/component after Ctrl+F not highlighted
wine-bugs at winehq.org
wine-bugs at winehq.org
Wed Nov 14 13:46:49 CST 2012
http://bugs.winehq.org/show_bug.cgi?id=32224
Bug #: 32224
Summary: LTspice: selected text/component after Ctrl+F not
highlighted
Product: Wine
Version: unspecified
Platform: x86-64
OS/Version: Linux
Status: UNCONFIRMED
Severity: minor
Priority: P2
Component: -unknown
AssignedTo: wine-bugs at winehq.org
ReportedBy: testelor at yahoo.com
Classification: Unclassified
Steps to reproduce:
1) Download and install LTspice -
http://ltspice.linear.com/software/LTspiceIV.exe
2) Run LTspice using:
$ wine scad3.exe -nowine
3) Create a new schematic, press 'R' (resistor), for example, and place
it twice by clicking. There should be R1 and R2 on the schematic.
4) Press Ctrl+F and search for "r2", no quotes, it should be highlighted in
yellow, but they're not.
Side note:
- create a new schematic, press F2 to bring up the device list.
- select current, place it on the schematic
- right-click on it and type '1', no quotes, then OK
- press 'R', place it next to the current source, in parallel
- right click on it and replace "R" with '1', no quotes, then OK
- press 'G' and place ground on the lower pins of both components
- press F3 and draw a net by clicking on the unconnected current source's pin,
then on the resistor's
- press 'S' and write ".tran 1", no quotes, don't forget the dot, place it on
the schematic
- in the toolbar, press the 'running man' button, or right-click on the
schematic and choose "run"
- it should be almost instant, a new empty window will pop up, above
- move the mouse cursor over the resistor until the cursor changes into a
current-clamp (something black with a red arrow), then click once to display
the current through the resistor
- in the newly created window, there will be a trace displayed and a label at
the top, reading I(R1)
Alt+left-clicking on the label will highlight the resistor. That's how it
should look like after Ctrl+F. Alternatively, you can just run "wine
scad3.exe", no "-nowine" switch, and repeat the 4 steps in the beginning.
No screenshot as it doesn't make sense to show what doesn't happen...
--
Configure bugmail: http://bugs.winehq.org/userprefs.cgi?tab=email
Do not reply to this email, post in Bugzilla using the
above URL to reply.
------- You are receiving this mail because: -------
You are watching all bug changes.
More information about the wine-bugs
mailing list