[Bug 39284] Keyboard entry problems in Turbocad 7.1

[wine-bugs at winehq.org]

https://bugs.winehq.org/show_bug.cgi?id=39284

--- Comment #4 from Ted Hansen <tedhansen at sasktel.net> ---
I have done some tests. It appears that Turbocad will actually respond to the
keyboard input but response is extremely slow, sometimes the key must be held
for 4 seconds or more before the program responds.

It also appears that this IS a bug which is dependent on the wine version. The
last wine version which works correctly is 1.4.

I performed tests using Ubuntu 12.04 and 14.04 and wine versions 1.4, 1.61,
1.62, 1.7.18 and 1.7.50. All tests were done with a clean, new Ubuntu install,
first using wine installed from the distribution repositories then with wine
packages installed from the ppa according to the instructions on winehq.

The ~.wine folder was deleted between each version tested so each test was with
a clean, new wine install.

On ubuntu 12.04: 
- wine 1.4 was OK. 
- with 1.6.1, 1.6.2 and 1.7.18 keyboard response was so slow as to make the
program unusable
1.7.18 is the highest ubuntu package available for 12.04

On ubuntu 14.04:
- attempting to install wine 1.4 actually installs 1.6.2. Turbocad runs but
keyboard response is too slow for it too be usable. 
- with wine 1.7.50 the program installs but will not run. It freezes at the
second opening screen ("start a new file, open and existing file, etc."). cpu
use goes to 100% and, if left for any length of time, the entire system freezes
and must be shut down by cutting the power.

-- 
Do not reply to this email, post in Bugzilla using the
above URL to reply.
You are receiving this mail because:
You are watching all bug changes.