[Wine] Re: Enter key disfunction on Arc+ progress 3 cad software

[Giamp]

James Mckenzie wrote:
> Giamp <wineforum-user at winehq.org> wrote:
> 
> > 
> > James McKenzie wrote:
> > 
> > > On 9/13/10 6:26 PM, Giamp wrote:
> > > 
> > > 
> > > > 
> > > > err:ole:CoCreateInstance apartment not initialised
> > > > err:ole:get_unmarshaler_from_stream Failed to create marshal, 0x800401f0
> > > > err:ole:CoReleaseMarshalData IMarshal::ReleaseMarshalData failed with error 0x8001011d
> > > > 
> > > > 
> > > > 
> > > Is this after you attempt to close the program?
> > > 
> > 
> > 
> > Yes. This is after i have closed the program.
> > 
> > 
> These errors can then be ignored as they are symptomatic of the program's failure to start-up.
> 
> 
> > The 'dongle' type device is required. It's an hardware level software protection that stands on parallel port and, in its
> > absence, prevents the program start but, at this moment, is not connected: the hardware protection is bypassed by a
> > software patch.
> > 
> 
> If you have the device, can you connect it up and see if the program works as it is supposed to?
> 
> James McKenzie



The device is on parallel port, that no longer exists but, trust me, the problem cannot be there.
The program works very well. Not only works the enter key.
So, you can't issue commands from the command line.
Thank you, James